Preston had a book report project due today. They were supposed to read a 'how-to' book, then make a locker and decorate the locker as if what they learned was a person. Anyway, Preston chose to read an Arduino book. Mike and Preston had fun working on his locker. The locker would open when you pushed a button. They 3D printed something that looked like a locker combination lock. When the button was pushed it moved back and forth like it was unlocking itself. It was quite amazing. Too bad that something went wrong in the transfer and the button stopped working. Preston is going to try and fix it tomorrow. They think it just needs something to support it. Like if they duct tape a knife behind it, or something so it doesn't fall in too much when the button is pushed. Anyway, the entire project is amazing.
Preston
No comments:
Post a Comment